Liquid Kraken Marine Grade Graphene Nano Coating

Liquid Kraken is a true marine grade graphene coating that is formulated specifically for gel coat and marine paints. The low VOC solvent based formula carries a high concentration of graphene oxide which forms a monolithic layer of protection one atom thick. This ultra slick finish is known to reduce water spotting by approximately 50%. Reduced water spotting is the number one selling point on why a boat owner would select a Liquid Kraken over a SiO2 based coating like Liquid Thor. SiO2 and Graphene based coatings have relatively the same level of gloss and durability. The life span of the coating will be a function of how often the vessel is used, stored and maintained. A general time frame would be roughly up to 12 to 24 months of protection before you would reapplication. Application requires preparation and respect. Surface must be fully corrected and decontaminated before Kraken touches it. IPA prep removes polishing residue that would prevent bonding. Apply with a suede applicator — 4 to 10 drops depending on surface area, thin and consistent strokes. The coating appears dark when wet. That is normal. That is the graphene. Watch for the corduroy pattern — when your application strokes become clearly visible across the surface, flash is complete and leveling begins. Two clean microfibers: primary towel to remove, insurance towel to catch any high spots. Twenty-four to 48 hours initial cure with no water contact. Seven to 14 days for full hardness development. Liquid Kraken works on most surfaces — gelcoat, marine paint, powder coat, and glass.